Previous Lesson

Treatment procedure

Treatment procedure:

Facial Treatment Procedure

  1. Lay the client on the couch and place a hair net on them to ensure no hair is obstructing the treatment area.
  2. Put gloves and cleanse the skin in small circular moves to remove impurities, rinse
  3. Deep cleanse to remove any remaining dirt, make up and debris, rinse
  4. Blot the skin dry
  5. Diagnose any areas of concern using a mag light that were not visible at consultation
  6. Document any issues you have highlighted on the clients chart notes and take photographs to support this
  7. Complete exfoliation to ensure there are no additional barriers to penetration of the BB serum
  8. Disinfect the face with a suitable skin disinfectant (vitasept or clinisept usually) avoiding the eyes, and blot the skin to ensure the skin is dry.
  9. If using a booster- this needs to be completed before the BB Glow pigment to achieve the best results. Select the booster that best matches your client’s needs. Pour a third approximately into the Petri dish
  10. Select your pigment(s) and prepare them with the dropper applicator
  11. Set up your device with the Nano-needle and adjust to a suitable depth.
  12. Paint on the serum to the clients skin and visually divide the face into sections, for example forehead, cheeks, chin, lip. Apply the pen so that the Nano needle is at a 90 degree angle (flat to the skin) and work in sections at a time. Keeping the hand piece vertical at all times, so the round end is in full contact with the skin, from the forehead work in counter clockwise circular operation. Do this for 3 minutes to work the serum into the skin, remember you may need to adjust the depth and regularly check your client is ok.
  13. Place the foundation droplets on the skin, according to the clients’ treatment plan, then work this into the skin using the same method as before. The general operation time 10-20 minutes. Repeat more passes of the entire area to ensure the serum is fully infused however you can also target specific areas that need extra time for absorption

  1. Dispose of the needle into the sharps box while the mask is on and record any results needed on the consultation sheet.
  2. Masks can be applied if you wish to.
  3. Blend any excess product and clients treatment can finish